|
PEX Radiant Concrete Floors (Slab on Grade)
For concrete floors (slab on grade), the Radiant PEX tubing is attached to the reinforcing mesh with cable ties before the slab is poured. This type of PEX Radiant Floor Heat System has a large mass.
With this type of radiant underfloor heating, the space can only changed by the radiant floor about 1/2 a degree per hour. Typically the water temperature used in pex water line for this type of radiant floor is between 90° and 115° Fahrenheit. It is imperative that the surface temperature of any PEX Radiant floor stays below 85° or it becomes uncomfortable and unsafe
|
|
PEX in thin slab over wood framing
Simpler in new construction but you can install this type of radiant floor as a retrofit, the radiant PEX Pipe is installed over framed floors and covered with concrete or lightweight concrete. We like this type of pex radiant floor heating the best. Our Radiant Floor Heat System is easy to install and it provides a very even heat. Thin slab PEX radiant floors have a much quicker response time. With this type of radiant floor the space it is heating can be changed by the radiant floor as fast as 2 a degree per hour. Thin slab radiant floors have many floor covering options. (tile, stained concrete, wood using sleepers, carpet, etc.). Typically the water temperature used in this type of radiant floor - the pex water lines are between 90° and 125° Fahrenheit. A quick note: When installing this type of pex radiant floor heat you need to have a tension break between the concrete and the wood substrate to allow the concrete and the wood floor to expand and shrink at there own rates. We recommend using 6 mil. sheet plastic.
|
|
PEX Radiant Tubing Under Floor
In a typical remodeling project, the PEX radiant tubing is hung with hangers below the floor about 1 inch. This allows the PEX radiant tubing to slide a little and sag a little as it expands making for a quiet floor. The hot water running through the PEX Radiant Floor Heat System Tubing heats the air which intern heats the floor above. A insulation with a reflective surface mounted facing up leaving a 3 to 4 inch air space to the bottom of the floor is required. The PEX Radiant Heat from this floor system is very even. The air in this space must be stagnant, meaning all penetrations must be calked and the floor joists where they meet the band joist also. Typically the temperature for this type of PEX installation is between 120 deg. and 165 deg. Fahrenheit. We know of many houses using this method, new construction and existing. In Vermont where tubing was hung 16 inches on center and the water temperature is run from 125 degrees to 180 degrees out of the boiler or with a mixing valve. This has kept houses at a comfortable range with efficiency and no noise. In warmer climates you can run with a cooler temperature, but all this depends on your house's heat loss and other factors.
|